It’s my goddamn motherfucking mobile data and MY PHONE. I should be able to use it however I want. My wifi went down because the greedy, cunt-faced shitbags at Comcast stole taxpayer subsidies to enrich themselves instead of actually providing the service we’re paying for. I tried to switch to a mobile hotspot and my phone refuses to open one. Everyone responsible for this shit should be fed to alligators locked away in a fucking gulag. We have no rights and live in a corporate plutocracy.

  • MigratingApe@lemmy.world
    link
    fedilink
    English
    arrow-up
    18
    ·
    11 months ago

    They detect lower than usual TTL of packets coming from your mobile device when it routes packets during tethering. They might also set TTL to 1 to packets going from internet to your mobile, so they get dropped instead of being forwarded further. You would need to plug the SIM card into your own modem+router combo with TTL modification rules in place to avoid detection. But then they might just block your modem by checking IMEI…

    • Boinketh@lemm.eeOP
      link
      fedilink
      English
      arrow-up
      25
      ·
      11 months ago

      Or we could cut their cocks off have a very nice chat with them about the ethics of taking advantage of consumers.

    • ∟⊔⊤∦∣≶@lemmy.nz
      link
      fedilink
      English
      arrow-up
      8
      ·
      11 months ago

      Is that actually it? So could software be written to just +1 TTL on incoming and -1 on outgoing packets and then problem solved?

      You would need pretty low level access so that comes around to custom rom again…

      You can spoof MACs so couldn’t you spoof a IMEI as well? Theoretically speaking, not on your bog standard $2 ISP modem

      • Spiralvortexisalie@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        11 months ago

        Yes, I don’t know all the solutions but one would be using iptables in linux and mangling the packets to adjust ttl, “normal” ttl can vary by carrier though, and with many phones there is an extra hop to account for as the phone is a router. You should be able to tell from a ping or trace route whats “normal”, but nowadays with carrier grade nat, I think it gets messed up sometimes.